HP Indigo 7800 ITM Bearings Alignment - Page 24
HP Indigo 7800 Manual
View all HP Indigo 7800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
8. From the front of the press, slide one of the chucks all the way into the ITM bearingNote that one of the three chuck bases will sit at the 6 o'clock position. Figure 5-17 Installing the ITM bearing alignment jig front chuck 1 Chuck base 9. Slide the second chuck on the jig shaft and secure it with the M6x25 screw provided. Figure 5-18 Installing the rear chuck on the ITM bearing alignment jig shaft 10. From the rear of the press, slide the chuck (which is attached to the jig shaft) through the ITM drum, all the way into the front chuck, which assembled on the front bearing. NOTE: Another person should hold the front chuck in place to prevent it from sliding out of the front ITM bearing. 22 Chapter 5 Aligning the ITM bearings
8.
From the front of the press, slide one of the chucks all the way into the ITM bearingNote that one of the
three chuck bases will sit at the 6 o’clock position.
Figure 5-17
Installing the ITM bearing alignment jig front chuck
1
Chuck base
9.
Slide the second chuck on the jig shaft and secure it with the M6x25 screw provided.
Figure 5-18
Installing the rear chuck on the ITM bearing alignment jig shaft
10.
From the rear of the press, slide the chuck (which is attached to the jig shaft) through the ITM drum, all
the way into the front chuck, which assembled on the front bearing.
NOTE:
Another person should hold the front chuck in place to prevent it from sliding out of the front
ITM bearing.
22
Chapter 5
Aligning the ITM bearings