HP Indigo 7800 ITM Bearings Alignment - Page 29

Finishing ITM bearings alignment,

Get HP Indigo 7800 PDF manuals and user guides View all HP Indigo 7800 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 29 highlights

6. Place the other parts and tools back in the case, as shown below. Figure 5-25 Placing the ITM bearing alignment jig back in the case Finishing ITM bearings alignment Follow these steps to finish ITM bearings alignment. 1. On the rear bearing, install the rear ITM locking ring as follows: a. Thoroughly clean the threads in the ITM drum shaft from all remains of old Omnifit/Loctite with IPA. NOTE: The picture below shows the new ITM bearing with eight holes. The older version has four holes. Finishing ITM bearings alignment 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
6.
Place the other parts and tools back in the case, as shown below.
Figure 5-25
Placing the ITM bearing alignment jig back in the case
Finishing ITM bearings alignment
Follow these steps to finish ITM bearings alignment.
1.
On the
rear
bearing, install the rear ITM locking ring as follows:
a.
Thoroughly clean the threads in the ITM drum shaft from all remains of old Omnifit/Loctite with IPA.
NOTE:
The picture below shows the new ITM bearing with eight holes. The older version has four
holes.
Finishing ITM bearings alignment
27