HP Integrity Superdome 2 8/16 Cisco Nexus B22 Fabric Extender for HP Getting S - Page 10
Disassociating a Fabric Extender from an Interface, Configuring the Fabric Extender
View all HP Integrity Superdome 2 8/16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Configuring the Cisco Nexus B22 Fabric Extender for HP Eth100/1/5 Eth100/1/9 Eth100/1/13 Eth100/1/6 Eth100/1/10 Eth100/1/14 Eth100/1/7 Eth100/1/11 Eth100/1/15 Eth100/1/8 Eth100/1/12 Eth100/1/16 Disassociating a Fabric Extender from an Interface To disassociate the Fabric Extender from an interface, perform this task: Command switch(config-if)# no fex associate Purpose Disassociates the Fabric Extender unit attached to the interface. Configuring the Fabric Extender To configure global features for a Fabric Extender, perform this tasks: Step 1 Step 2 Step 3 Command Purpose switch# configure terminal Enters configuration mode. switch(config)# fex chassis Enters configuration mode for the specified Fabric Extender chassis ID. The range of the chassis ID is from 100 to 199. switch(config-fex)# description desc Specifies the description. The default is the string FEXxxxx where xxxx is the chassis ID. If the chassis ID is 123, the description is FEX0123. switch(config-fex)# no description Deletes the description. switch(config-fex)# pinning max-links uplinks Defines the number of uplinks. The default is 1. The range is from 1 to 4. This command is only applicable if the Fabric Extender is connected to its parent switch using one or more statically pinned fabric interfaces. There can only be one EtherChannel connection. switch(config-fex)# no pinning max-links Resets the number of uplinks to the default. switch(config-fex)# serial serial Defines a serial number string. If this command is configured, then a switch will only allow the corresponding chassis ID to associate (using the fex associate command) if the Fabric Extender reports a matching serial number string. Configuring a serial number other than that of the given Fabric Extender will force the Fabric Extender offline. switch(config-fex)# no serial Deletes the serial number string. switch(config-fex)# beacon Turns on the beacon LED. This LED allows you to locate a specific Fabric Extender in a rack. switch(config-fex)# no beacon Turns off the beacon LED. Cisco Nexus B22 Fabric Extender for HP Getting Started Guide 10