HP Integrity Superdome 2 8/16 HP Superdome 2 Health Management Stack Whitepape - Page 13
Con SNMP from the OA CLI,
View all HP Integrity Superdome 2 8/16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Configure SNMP from the OA CLI: 1. ENABLE SNMP: Enables SNMP Trap support for the Onboard Administrator. 2. ADD SNMP TRAPRECEIVER [ "" ]: Adds a new trap receiver address to the SNMP configuration. By default the community name/string is set to 'public' or the optional "". A maximum of eight IP addresses can be added to receive SNMP traps. 3. TEST SNMP: Sends a test SNMP trap to all of the configured trap destinations. To removes the IP address from the list of trap receivers use the OA CLI Command: REMOVE SNMP TRAPRECEIVER []. You can disable the SNMP using the DISABLE SNMP CLI Command, but it does not clear the SNMP trap receivers that have been configured. Figure 4: SNMP Settings OA GUI Screen 13
13
Configure SNMP from the OA CLI:
1.
ENABLE SNMP: Enables SNMP Trap support for the Onboard Administrator.
2.
ADD SNMP TRAPRECEIVER <ip address> [ "<community name>" ]: Adds a new trap receiver address
to the SNMP configuration. By default the community name/string is set to 'public' or the optional
"<community name>".
A maximum of eight IP addresses can be added to receive SNMP traps.
3.
TEST SNMP: Sends a test SNMP trap to all of the configured trap destinations.
To removes the IP address from the list of trap receivers use the OA CLI Command: REMOVE SNMP
TRAPRECEIVER <ip address> [<community>]. You can disable the SNMP using the DISABLE SNMP CLI
Command, but it does not clear the SNMP trap receivers that have been configured.
Figure 4
: SNMP Settings OA GUI Screen