HP Integrity rx1620 HP Management Base Installation and User's Guide for Linux - Page 23
The Management Processor MP card on HP Integrity Servers supports RMCP, IPMIraw NetFn/LUN Cmd
View all HP Integrity rx1620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
IPMIraw NetFn/LUN Cmd [data1 data2 ...] Takes the hexadecimal bytes and sends them directly to the target device. Output is printed as a block of hexadecimal bytes, although no length information is explicitly given. The user must know how to interpret the bytes. For example, hpbmc IPMIraw 18 1 is the Get Device ID command. IPMBgetaddr Returns the apparent bus address of the Open IPMI device; cannot be used with the -b option. This may reflect a wake up value (typically hex 20) and might not be an actual assigned address (as with an ATCA chassis). See the next command. IPMBsetaddr [newaddr ] Sets the apparent bus address of the Open IPMI device; cannot be used with the -b option. This value is persistent until changed or the system is rebooted. newaddr is an eight-bit IPMB address in hexadecimal (i.e., A2). If it is missing or set to FF, hpbmc will probe all addresses for the one that matches actually hardware assignment (as with an ATCA chassis). MIBprint hpbmc embodies full textual descriptions and SNMP trap information for many IPMI SEL events. This directive prints all that information in the form of a MIB. You can typically find this MIB in /usr/share/snmp/mibs/ HPIPFTRAP-MIB.txt. It should be created by the hpmgmtbase install scripts so MIBprint is not normally used. Partname [newname ] (Integrity cellular systems only) Print the name of the partition on which the command is run. It cannot be run remotely over RMCP. When given an optional argument, an attempt is made to rename the partition. Partprint (Integrity only) On entry-level boxes, print the "parts": installed CPUs, installed IO cards, and RAM population. On partitioned systems it adds partition names, cell assignments, and cell-to-chassis associations. Power [on | offNow ] Without the optional modifier, display the current chassis power state. The modifier can change the current state. On HP Integrity servers this can only be used with -b 46run locally via IPMI, or directly to the MP card with RMCP. RMCPpasswd The Management Processor (MP) card on HP Integrity Servers supports RMCP operation for current firmware revisions. On entry-level systems (non- cellular) RMCP must first be enabled via an interactive session to the MP. The default password is null (no password), and can only be changed via this directive. Mid-range and high-end servers (cellular) can set the password via this directive or the interactive MP session. See the ENVIRONMENT VARIABLES section for password usage. SDRprint Print a verbose list of all entries in the Sensor Data Record Repository. An entry is summarized on a single line, followed by a type description and pertinent details. Not all of the entries are useful to the casual observer. The following types may be seen: C Sensor Compact sensor that returns state information 23