HP J4903A User Manual - Page 35
Horizontal Surface Mounting, 5. Connect the Switch to a Power Source
View all HP J4903A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Caution Installing the Switch Installation Procedures Horizontal Surface Mounting Place the switch on a table or other horizontal surface. The switch comes with rubber feet in the accessory kit that can be used to help keep the switch from sliding on the surface. Attach the rubber feet to the four corners on the bottom of the switch within the embossed angled lines. Use a sturdy surface in an uncluttered area. You may want to secure the networking cables and switch power cord to the table leg or other part of the surface structure to help prevent tripping over the cords. Make sure the air flow is not restricted around the sides and back of the switch. 5. Connect the Switch to a Power Source 1. Plug the included power cord into the switch's power connector and into a nearby AC power source. 2. Re-check the LEDs during self test. See "LED Behavior" on page 2-10 Installing the Switch 2-17