HP Jetdirect 610n HP Jetdirect 200m Print Server - (English) Administrator Gui - Page 220
Table 9.6, TCP/IP Configuration Information 2 of 4, HP Jetdirect Configuration
View all HP Jetdirect 610n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 220 highlights
Table 9.6 TCP/IP Configuration Information (2 of 4) Message Description DEFAULT GATEWAY: The IP address of the gateway used when sending packets off the local network. Only one default gateway may be configured. During initialization, a temporary value 0.0.0.0 is displayed. If not provided, the IP address of the Jetdirect print server is used. NOT SPECIFIED: Indicates that a default gateway is not configured. CONFIG BY: Identifies how the HP Jetdirect print server obtained its IP configuration: BOOTP: Automatic configuration through a BOOTP server. BOOTP/TFTP: Automaticautomatic configuration through a BOOTP server and TFTP configuration file. DHCP: Automatic configuration through a DHCP server DHCP/TFTP: Automatic configuration through a DHCP server and TFTP configuration file. RARP: Automatic configuration through the Reverse Address Resolution Protocol. USER SPECIFIED: Manual configuration through Telnet, the printer's control panel, HP Web Jetadmin, embedded Web server, or other method. DEFAULT IP: The default IP address was assigned. This address may not be a valid address for your network. AUTO IP: A link-local IP address (169.254.x.x) was assigned. If the network is a link-local network, this address should be valid. NOT CONFIGURED: The print server was not configured with IP parameters. Verify that TCP/IP is enabled, or check for error status. BOOTP SERVER: or DHCP SERVER: or RARP SERVER: Displayed if BOOTP, DHCP, or RARP is used for TCP/IP configuration. It specifies the IP address of the system that responds to the HP Jetdirect print server's request for automatic TCP/IP configuration over the network. NOT SPECIFIED: Indicates that the configuration server's IP address could not be determined or was set to zero in the response packet. BOOTP/DHCP SERVER: Displayed during initialization while the HP Jetdirect print server attempts to obtain its TCP/IP configuration from a BOOTP or DHCP server. The temporary address displayed is 0.0.0.0. ENWW HP Jetdirect Configuration Page 220