HP L1940 HP L1740 17" and L1940 19" Flat Panel Monitors User Guide - - Page 20

Setting Up the Monitor Removing the Monitor Base The monitor base can be removed to mount the monitor on a wall, a swing arm or other mounting fixture. Read the caution and warning statements below before beginning the procedure. Ä CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected. Lay the front bezel down on a soft area to prevent it from getting scratched, defaced, or broken Å WARNING: Do not remove the base from the monitor while the monitor is in the upright position. Before removing the monitor from the base, ensure that the monitor is lying flat, front bezel down, and that the base is set to the maximum base extension. Attempting to remove the monitor from the base while upright in the minimum base extension may result in injury to the user. 1. Disconnect and remove the signal and power cables from the back of the monitor. Ä CAUTION: Ensure that the bottom of the monitor base is positioned over a table or desktop before removing the base from the monitor. 3-10 User Guide