HP M4345xs User Guide - Page 63

Troubleshooting menu NOTE Values shown with "(default)" are the factory-default values. Some menu items have no default. Table 2-16 Troubleshooting menu Menu item Event Log Sub-menu item Sub-menu item Calibrate Scanner Fax T.30 Trace Print T.30 Report When to Print Report Fax Transmit Signal Loss Fax V.34 Fax Speaker Mode Paper Path Sensors Values Description Print (button) Calibrate (button) This feature shows the event codes and their corresponding engine cycles on the display, and it allows you to print the full event log. Use this feature to compensate for offsets in the scanner imaging system (carriage head) for ADF and flatbed scans. You might need to calibrate the scanner if it is not capturing the correct sections of scanned documents. Never auto print Print after any fax job Use this feature to print or configure the fax T.30 trace report. T.30 is the standard that specifies handshaking, protocols, and error correction between fax machines. Print after fax send jobs Print after any fax error Print after send errors only Print after receive errors only A value between 0 and 30. Use this feature to set loss levels to compensate for phone line signal loss. You should not modify this setting unless requested to do so by an HP service representative because it could cause the fax to stop functioning. Normal (default) Off Normal (default) Diagnostic Use this feature to disable V.34 modulations if several fax failures have occurred or if phone line conditions require it. This feature can be used by a technician to evaluate and diagnose fax issues by listening to the sounds of fax modulations. The factory default setting is Normal. Initiate a test of the paper path sensors. ENWW Troubleshooting menu 51