HP Mini 730 HP Mini 1000 and Compaq Mini 700 - Maintenance and Service Guide - Page 66
and the heat sink
View all HP Mini 730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
2. Remove the heat sink assembly (2). NOTE: Due to the adhesive quality of the thermal material located between the heat sink assembly and system board components, it may be necessary to move the heat sink assembly from side to side to detach the assembly. NOTE: The thermal material must be thoroughly cleaned from the surfaces of the heat sink assembly and the system board each time the heat sink assembly is removed. Thermal paste is used on the processor (1), the heat sink section (2) that services the processor, the Northbridge chip (3), and the heat sink section (4) that services the Northbridge chip. Replacement thermal material is included with all heat sink assembly and system board spare part kits. Reverse this procedure to install the heat sink assembly. 58 Chapter 4 Removal and replacement procedures