HP Model 748 HP Model 748 Service Handbook - Page 64
Removing Mass Storage Module, Procedure
View all HP Model 748 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Removing and Replacing Mass Storage Devices Removing Mass Storage Module CAUTION: The mass storage module can weigh about 10 lbs, and may be awkwardly balanced. Use care when handling the module, as dropping it could damage the mass storage devices! NOTE: All Installation procedures are the reverse of removal in this section. Procedure 1 Disconnect any SCSI cables connected to module. 2 Unscrew both Mass Storage Module screws. 3 Slide out tray. See Figure 5-6. 4 If replacing a device go to Selecting Device Address. 5 If the only action is to remove a device go to Mass Storage Device Removal. Figure 5-6 Mass Storage Tray Removal 5-16
Removing and Replacing Mass Storage Devices
5-16
Removing Mass Storage Module
CAUTION:
The mass storage module can weigh about 10 lbs, and may be
awkwardly balanced. Use care when handling the module, as
dropping it could damage the mass storage devices!
NOTE:
All Installation procedures are the reverse of removal in this
section.
Procedure
1
Disconnect any SCSI cables connected to module.
2
Unscrew both Mass Storage Module screws.
3
Slide out tray. See Figure 5-6.
4
If replacing a device go to Selecting Device Address.
5
If the only action is to remove a device go to Mass Storage Device Removal.
Figure 5-6
Mass Storage Tray Removal