HP Nc2400 ProtectTools - Page 48
Enabling and disabling power-on authentication support for Embedded Security
UPC - 883585088331
View all HP Nc2400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Enabling and disabling power-on authentication support for Embedded Security Enabling this option allows the system to use the TPM embedded security chip (if available) for user authentication when you turn on the computer. NOTE To fully enable the power-on authentication feature, you must also configure the TPM embedded security chip using the Embedded Security for ProtectTools module. To enable power-on authentication support for embedded security: 1. Select Start > All Programs > HP ProtectTools Security Manager. 2. In the left pane, select BIOS Configuration. 3. Enter your Computer Setup administrator password at the BIOS administrator password prompt, and then click OK. 4. In the left pane, select Security. 5. Under Embedded Security, select Enable Power-on Authentication Support. NOTE To disable power-on authentication for Embedded Security, select Disable. 6. Click Apply, and then click OK in the ProtectTools window to save your changes. 42 Chapter 5 BIOS Configuration for ProtectTools ENWW