HP Pavilion xe700 HP Pavilion PC's - (English) Seagate Hard Drive U Series 5 M - Page 25

Jumper settings, Master/slave configuration

Get HP Pavilion xe700 - Desktop PC PDF manuals and user guides View all HP Pavilion xe700 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

18 U Series 5 Family Product Manual, Rev. B 2.2 Jumper settings 2.2.1 Master/slave configuration The options jumper block shown in Figure 2 is used to configure the drive for operation. It is the 8-pin dual header between the interface connector and the power connector. Use the following settings to configure the drive as a master or a slave. Master or single drive. The drive is configured at the factory for a master or single-drive operation with a jumper set on pins 7 and 8. Drive as slave. Remove all jumpers. Drive as master with a non-ATA-compatible slave. Set a jumper on pins 5 and 6 and a jumper on pins 7 and 8. Use this jumper setting only if the drive does not work as a master with no jumpers installed. Options jumper block Master or single drive Drive is slave Master with non ATAcompatible slave Cable select Limit drive capacity 40 Gbytes = 32 GB

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
18
U Series 5 Family Product Manual, Rev. B
2.2
Jumper settings
2.2.1
Master/slave configuration
The options jumper block shown in Figure 2 is used to configure the drive
for operation. It is the 8-pin dual header between the interface connector
and the power connector. Use the following settings to configure the
drive as a master or a slave.
Master or single drive
. The drive is configured at the factory for a master
or single-drive operation with a jumper set on pins 7 and 8.
Drive as slave
. Remove all jumpers.
Drive as master with a non-ATA-compatible slave
.
Set a jumper on pins 5 and 6 and a jumper on pins 7 and 8. Use this
jumper setting
only
if the drive does not work as a master with no jumpers
installed.
Figure 2. Master/slave jumper settings
Options jumper block
Circuit Board
2
6
8
4
1
7
5
3
Drive is slave
Master or single drive
Cable select
Master with non ATA-
compatible slave
Limit drive capacity
40 Gbytes = 32 GB
<40 Gbytes = 2.1 Gbytes