HP Photosmart 2700 Users Guide - Page 107

Chapter 11 2 Press 5, and then press 6. This displays the Advanced Fax Setup menu and then selects Error Correction Mode. 3 Press to select Off or On. 4 Press OK. Set the fax speed You can set the fax speed used to communicate between your HP all-in-one and other fax machines when sending and receiving faxes. The default fax speed is Fast. If you use one of the following, setting the fax speed to a slower speed might be required: ● An Internet phone service ● A PBX system ● Fax over Internet Protocol (FoIP) ● An integrated services digital network (ISDN) service If you experience problems sending and receiving faxes, you might want to try setting the Fax Speed setting to Medium or Slow. The following table provides the available fax speed settings. Fax speed setting Fast Medium Slow Fax speed v.34 (33600 baud) v.17 (14400 baud) v.29 (9600 baud) To set the fax speed from the control panel 1 Press Setup. 2 Press 5, and then press 7. This displays the Advanced Fax Setup menu and then selects Fax Speed. 3 Press to select an option, and then press OK. Reprint or delete the faxes in memory You can reprint or delete the faxes stored in memory. You might need to reprint a fax in memory if your HP all-in-one runs out of paper while receiving a fax. Or, if the memory of the HP all-in-one becomes full, you might need to clear it in order to continue receiving faxes. Note The HP all-in-one stores all faxes it receives in memory, even when the faxes are printed. This allows you to reprint the faxes later, if needed. After the memory becomes full, the HP all-in-one overwrites the oldest, printed faxes as it receives new faxes. To reprint faxes in memory from the control panel 1 Make sure you have paper loaded in the input tray. 2 Press Setup. 3 Press 6, and then press 4. This displays the Tools menu and then selects Reprint Faxes in Memory. Use the fax features 104 HP Photosmart 2600/2700 series all-in-one