HP Pro 2000 Hardware Reference Guide - HP Pro 2000 and 3000 Series Microtower - Page 18
Securing the Expansion Cards and Slot Covers - seat
View all HP Pro 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
11. To install a new expansion card, hold the card just above the expansion socket on the system board then move the card toward the rear of the chassis so that the bottom of the bracket on the card slides into the small slot on the chassis. Press the card straight down into the expansion socket on the system board. Figure 11 Installing an Expansion Card NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot. 12. Replace the slot cover lock and secure it in place with the screw that was previously removed. Figure 12 Securing the Expansion Cards and Slot Covers 13. Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed. 14. Replace the computer access panel. 15. Reconnect the power cord and any external devices, then turn on the computer. 12 Hardware Upgrades