HP Pro 2000 Hardware Reference Guide - HP Pro 2000 and 3000 Series Microtower - Page 34
Installing a Security Lock
View all HP Pro 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
b. Insert the new battery and position the clip back into place. Figure 32 Removing a Coin Cell Battery (Type 3) NOTE: After the battery has been replaced, use the following steps to complete this procedure. 8. Replace the computer access panel. 9. Plug in the computer and turn on power to the computer. 10. Reset the date and time, your passwords, and any special system setups using Computer Setup. 11. Lock any security devices that were disengaged when the access panel was removed. Installing a Security Lock The security locks displayed below and on the following pages can be used to secure the computer. 28 Hardware Upgrades
b.
Insert the new battery and position the clip back into place.
Figure 32
Removing a Coin Cell Battery (Type 3)
NOTE:
After the battery has been replaced, use the following steps to complete this procedure.
8.
Replace the computer access panel.
9.
Plug in the computer and turn on power to the computer.
10.
Reset the date and time, your passwords, and any special system setups using Computer Setup.
11.
Lock any security devices that were disengaged when the access panel was removed.
Installing a Security Lock
The security locks displayed below and on the following pages can be used to secure the computer.
28
Hardware Upgrades