HP Pro 2000 Maintenance & Service Guide: HP Pro 2000/2080 Business PC - Page 36
Bezel Blanks
View all HP Pro 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Bezel Blanks On some models, there are bezel blanks covering the 3.5-inch and 5.25-inch external drive bays that need to be removed before installing a drive. To remove a bezel blank: 1. Remove the front bezel (Front Bezel on page 27). 2. To remove the lower 5.25-inch bezel blank, gently twist and pull on the bezel blank until it breaks free from the front bezel (1), then discard the bezel blank. If the blank needs to be replaced at a later date, you can order a replacement blank from HP. 3. To remove the 3.5-inch bezel blank, press the two retaining tabs towards the outer left edge of the bezel (2) and pull the bezel blank inwards to free it from the front bezel (3). Figure 6-3 Removing a Bezel Blank 4. Replace the front bezel. 28 Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis