HP Pro SFF 290 G9 Desktop PC Maintenance and Service Guide - Page 42
Power supply
View all HP Pro SFF 290 G9 Desktop PC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
1. Prepare the computer for disassembly (see Preparation for disassembly on page 18). 2. Remove the access panel (see Access panel on page 19). 3. Remove the fan duct (see Fan duct on page 33). 4. Remove the heat sink with fan (see Heat sink with fan on page 33). Remove the processor: 1. Pull the locking lever away from the processor (1), and then rotate the lever to its fully open position (2). 2. Raise and rotate the microprocessor retainer to its fully open position (3). 3. Carefully lift the processor from the socket (4). IMPORTANT: Do not handle the pins in the processor socket. These pins are fragile, and handling them could cause irreparable damage. If pins are damaged, you might have to replace the system board. The heat sink must be installed within 24 hours of installing the processor to prevent damage to the processor's solder connections. To replace the processor, reverse the removal procedures. NOTE: After installing a new processor onto the system board, always update the system ROM to ensure that the latest version of the BIOS is being used on the computer. Power supply To remove the power supply, use these procedures. Before removing the power supply, follow these steps: 1. Prepare the computer for disassembly (see Preparation for disassembly on page 18). Power supply 35