HP ProLiant 1200 Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance an - Page 122
Run Options ROMPaq to, Upgrade Utility. However,
View all HP ProLiant 1200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
3-68 Diagnostic Tools DAAD Diagnostic Messages Continued Message Description Drive (bay) X is a This drive has been replaced replacement drive and marked OK by the marked OK firmware. This may occur if a drive has an intermittent failure (for example, if a drive has previously failed, then when DAAD is run, the drive starts working again). Drive (bay) X is The indicated physical drive failed has failed. Drive (bay) X has Drive has insufficient capacity insufficient to be used in this logical drive capacity for its configuration. configuration Drive (bay) X is This drive is being rebuilt from undergoing drive the corresponding mirror or recovery parity data. Drive (bay) X was The physical drive was inadvertently incorrectly replaced after replaced another drive failed. SCSI port X, drive ID Y firmware needs upgrading Set configuration command issued Soft Firmware Upgrade required Drive's firmware may cause problems and should be upgraded. The configuration of the array controller has been updated. The array accelerator board may remain disabled until it is reinitialized. DAAD has determined that your controller is running firmware that has been soft upgraded by the Compaq Upgrade Utility. However, the firmware running is not present on all drives. This could be caused by the addition of new drives in the system. Recommended Action Replace the drive. Replace this drive. Replace this drive with a larger capacity drive. Normal operations should occur. Replace the drive that was incorrectly replaced and replace the original drive that failed. Do not run the System Configuration Utility and try to reconfigure; data will be lost. Run Options ROMPaq to upgrade the drive's firmware to a later revision. Run the System Configuration Utility to reinitialize the array accelerator board. Run the Compaq Upgrade Utility to place the latest firmware on all drives.