HP ProSignia 320 Desktop PC 6400C Compaq Deskpro Family of Personal Computers, - Page 63
Screen Message, Beeps, Probable Cause, Recommended Action, POST Error Messages
View all HP ProSignia 320 Desktop PC 6400C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
POST Error Messages Continued Screen Message 163-Time & Date Not Set Beeps* 2S Probable Cause Invalid time or date in configuration memory. RTC (real-time clock) battery may need to be replaced. Battery life is approximately 3 years. CMOS jumper may not be properly installed. 164-Memory Size Error 2S Memory configuration is incorrect. 183-Invalid Processor Jumper Setting 201-Memory Error 2S None System board jumper improperly set. RAM failure. 202-Memory Type Mismatch None 207-ECC Corrected Single 2S Bit Errors in DIMM/SIMM Pair(s) X,X,... in Memory Socket(s) y,y * L = Long, S = Short Memory modules do not match each other. Single Bit ECC error. Recommended Action Set the date and time under Control Panel. If the problem persists, replace the RTC battery. Check for proper placement of the CMOS jumper. 1. Run Computer Setup (F10 Setup) or Windows utilities. 2. Make sure memory module(s) (if any) are installed properly. 3. Verify proper memory module type. 4. If third-party memory has been added, test using Compaq-only memory. Reset system board jumpers to match processor and bus speeds. 1. Run computer Setup (F10 Setup) or Windows utilities. 2. Ensure memory and continuity modules are installed correctly. 3. Verify proper memory module type. 4. Remove and replace memory module(s) one at a time to isolate faulty module. 5. Replace the faulty memory module(s). 6. If error persists after replacing memory modules, replace the system board. Replace memory modules with matched sets. 1. Verify proper memory module type. 2. Try another memory socket. 3. Replace memory module if problem persists. continued B-2 POST Error Messages - Numbered