HP ProSignia 320 Desktop PC 6400C Compaq Deskpro Family of Personal Computers, - Page 73
Error message, Probable Cause, Recommended Action, Post Error Messages - Not Numbered
View all HP ProSignia 320 Desktop PC 6400C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Error message Diskette Drive A or B Error Probable Cause Drive A: or B: is present, but fails the BIOS POST diskette tests. Recommended Action 1. Run Setup. 2. Replace the signal cable. 3. Replace the drive. Extended RAM Failed at Offset, nnn Extended memory is not working or is not configured properly. 1. Replace the memory modules. 2. Replace the system board. Failing Bits nnn nnn is a map of the bits at the 1. Run Setup. RAM address which failed the 2. Replace the system board. memory test. Fixed Disk 0 or 1 Failure Hard drive is not working or is not configured properly. 1. Run Setup. 2. Replace the signal cable. 3. Replace the hard drive. Fixed Disk Controller Failure Hard drive is not working or is 1. Run Setup. not configured properly. 2. Replace the system board. Incorrect Drive A Type Type of diskette in drive A: is 1. Run Setup. not correctly identified. 2. Replace the diskette drive. Invalid NVRAM Media Type Problem with NVRAM (CMOS) access. Replace the system board. Keyboard Controller Error Keyboard, I/O keyboard controller (on system board), or mouse error. 1. Replace the keyboard. 2. Replace the mouse. 3. Replace the system board. Keyboard Error Keyboard, I/O keyboard controller (on system board), or mouse error. 1. Replace the keyboard. 2. Replace the mouse. 3. Replace the system board. Operating System Not Found Operating system cannot be located on either drive A: or C:. Run Setup. Parity Check 1 Parity error found in the system bus. 1. Run Setup. 2. Replace the memory modules. 3. Replace the system board. Parity Check 2 Parity error found in the I/O bus. 1. Run Setup. 2. Replace the ISA board (modem). Real Time Clock Error Real-time clock fails BIOS test. Replace the system board. System Battery is Dead RTC battery is dead. 1. Replace the RTC battery. 2. Run Setup. Continued C-2 Post Error Messages - Not Numbered