HP RP7 HP Retail RP7 VFD Customer Display Installation Instructions - Page 1
HP RP7 Manual
View all HP RP7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HP Retail RP7 VFD Customer Display Installation Instructions Installing the VFD with No Poles Attached (see reverse side for installing the VFD using one or two poles) 1. Slide down the two levers on the upper corners of the rear I/O panel 1 and rotate the cover off 2. 4. Route the VFD extension cable that was included with the VFD through the rear of the base and out the front of the base 1, then through the cable retainer 2. Connect the extension cable to the I/O cable included with the VFD 3 and connect the I/O cable to the 12V USB port on the RP7. 7. Insert the VFD cable through the center of the mounting bracket 1 and slide the VFD onto the mounting bracket 2. 10. Replace the power supply cover by lowering it down over the neck of the base then sliding it back until it snaps in place. © Copyright 2012 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice.The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. Printed in First Edition: May 2012 691056-001 2. Pull the power supply cover back then lift if up and off the unit. 5. Wrap the excess extension cable around the hooks on the rear of the base. 8. Lay the VFD face down on clean, dry cloth and connect the VFD cable to the extension cable. 11. Replace the rear I/O cover by placing the hooks on the bottom of the cover into the slots on the bottom of the chassis 1. Then rotate the top of the I/O cover up so that it snaps securely onto the chassis 2. Before Your Begin Before installing the vacuum fluorescent display (VFD), be sure to power off the system and disconnect the power cord from the power outlet. WARNING! To avoid the risk of serious injury, ensure that the power cord is unplugged from the electrical outlet at the wall before installing the VFD. Failure to do so may expose you to the risk of electric shock. CAUTION: To avoid the risk of damage to the system, ensure that the power cord is unplugged from the electrical outlet at the wall before installing the VFD. 3. Remove the decorative panel on the rear of the unit by gently prying the panel away from the base at the tab locations on the top and sides of the panel as indicated below 1. Then pull the top of the panel away from the base 2 and push straight down on the panel to release the bottom tabs 3. 6. Insert the end of the extension cable through the hole in the decorative panel 1 and snap the decorative panel onto the rear of the base 2. 9. Slide the VFD mounting bracket into the mounting hole on the rear of the RP7 base 1, and install the two screws included with the VFD into the screw holes on top of the mounting bracket 2. To configure the VFD, refer to the HP Point of Sale Configuration Guide (available in English only). The guide is available on the HP factory image of the RP7 system's hard drive and at www.hp.com. To access the guide on the factory image: • In Windows Embedded POSReady 2009, select Start > All Programs > HP Point of Sale Information. • In Windows 7 or Windows Embedded POSReady 7, select Start > HP Point of Sale Information.