HP Scanjet 1000 User Guide - Page 12
Removing the monitor stand, IMPORTANT
View all HP Scanjet 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Removing the monitor stand IMPORTANT: Before beginning to disassemble the monitor, be sure that the monitor is turned off and all cables are disconnected. 1. Disconnect and remove all cables from the monitor. 2. Position the monitor facedown on a flat surface covered by protective sheet made of foam or a clean, dry cloth. 3. Push up on the latch near the bottom center of the stand's mounting plate (1). 4. Swing the bottom of the stand up until the mounting plate clears the recess in the monitor head (2). 5. Slide the stand out of the recess. 6 Chapter 1 Getting started
Removing the monitor stand
IMPORTANT:
Before beginning to disassemble the monitor, be sure that the monitor is turned off and all
cables are disconnected.
1.
Disconnect and remove all cables from the monitor.
2.
Position the monitor facedown on a flat surface covered by protective sheet made of foam or a clean,
dry cloth.
3.
Push up on the latch near the bottom center of the stand’s mounting plate (1).
4.
Swing the bottom of the stand up until the mounting plate clears the recess in the monitor head (2).
5.
Slide the stand out of the recess.
6
Chapter 1
Getting started