HP Scitex LX850 HP Scitex LX850 & LX820 Printers: Site Preparation Checkli - Page 6

Electrical installation Yes No Comments Has the single-phase branch circuit breaker (2 poles, 20 A) been correctly installed? Would the printer's integrated residual current circuit breakers (also known as the GFI) operate in case of a current leakage fault to the printer's chassis (even if an isolation device is installed)? (Required) (Required) Is the grounding conductor properly installed? (Required) Have you booked the services of an electrician for the day of installation? (Required) Is the electrician aware of all requirements and specifications highlighted in this document? (Required) Is the Power Distribution Unit (PDU) correctly installed? (Required) Is the tri-phase line-to line voltage inside the specified voltage range: 200- 220 V~ (±10%) or 380-415 V~ (-10%, +6%)? Is the single-phase line voltage inside the specified voltage range: 115-127 V~ (±10%) or 200-240 V~ (-10%, +6%)? Specify nominal mains voltage: Specify nominal mains voltage: Checklist Electrical configuration Yes No Do you need an Uninterrupted Power Supply (UPS)? If so, is it correctly installed? Will the power supply be more than five meters from the printer? If so, does the electrician understand that the single phase power cable will require an extension? A three-phase power cord is not supplied with the printer, does the electrician understand that a three-phase power cord must be provided according to printer specifications and local laws? If local regulations specify that you must use electrical plugs to connect the printer to the power supply, does the electrician have the required plugs ready for installation? Comments Networking requirements Have network connections been supplied? Do you have a LAN cable long enough to connect the printer to the network? Yes No Comments Equipment preparation Is the air compressor or pressurized air line ready for the day installation? Have the correct supplies been ordered for deliver on or before the date of the printer's installation? Minimum requirements: 1 set of ink cartridges. Recommended: 1 set of ink cartridges, an extra set of ink cartridges, correct substrate for training purposes. Yes No Comments 4 Chapter 2 Checklist ENWW