HP Scitex LX850 HP Scitex LX850 & LX820 Printers: Dual Roll Kit User's Gui - Page 10

Substrate management, Carriage beam position, Move to, highest position

Get HP Scitex LX850 PDF manuals and user guides View all HP Scitex LX850 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

4. If you need to raise the carriage beam, go to the front panel and select the Substrate menu , then Substrate management, and press OK. Select Carriage beam position > Move to highest position. This process takes about 2 minutes to complete. The printer raises the carriage beam, making it easy to insert the substrate. This process takes about 2 minutes to complete. During this period, you can load the input and output rolls. NOTE: While the carriage beam is rising, you can stop it by pressing the Cancel key. 5. You may find it helpful to lock the differentials on the input and output spindles while loading. Dual-roll spindle 6. Bring the new rolls on their spindle to the rear of the printer, with the geared end of the spindle on the left. 7. If the two rolls are of unequal lengths, the longer roll should be on the right as seen from the front of the printer; on the left as seen from the rear. NOTE: When the shorter roll comes to an end, you should lock the differential hub if you intend to continue printing on the longer roll. 8. Rest the ends of the spindle on the platforms provided at the rear of the printer; plastic pads are provided to absorb the impacts. 6 Chapter 2 Use of the dual-roll spindle ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
4.
If you need to raise the carriage beam, go to the front panel and select the Substrate menu
,
then
Substrate management
, and press
OK
. Select
Carriage beam position
>
Move to
highest position
. This process takes about 2 minutes to complete.
The printer raises the carriage beam, making it easy to insert the substrate. This process takes
about 2 minutes to complete. During this period, you can load the input and output rolls.
NOTE:
While the carriage beam is rising, you can stop it by pressing the
Cancel
key.
5.
You may find it helpful to lock the differentials on the input and output spindles while loading.
6.
Bring the new rolls on their spindle to the rear of the printer, with the geared end of the spindle on
the left.
7.
If the two rolls are of unequal lengths, the longer roll should be on the right as seen from the front
of the printer; on the left as seen from the rear.
NOTE:
When the shorter roll comes to an end, you should lock the differential hub if you intend
to continue printing on the longer roll.
8.
Rest the ends of the spindle on the platforms provided at the rear of the printer; plastic pads are
provided to absorb the impacts.
6
Chapter 2
Use of the dual-roll spindle
ENWW
Dual-roll spindle