HP SignagePlayer mp8000r Hardware Reference Guide - Page 59
B-3, Removing a Coin Cell Battery Type 3
View all HP SignagePlayer mp8000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Type 3 a. Pull back on the clip (1) that is holding the battery in place, and remove the battery (2). b. Insert the new battery and position the clip back into place. Figure B-3 Removing a Coin Cell Battery (Type 3) NOTE: After the battery has been replaced, use the following steps to complete this procedure. 9. Replace the access panel. 10. If the computer was on a stand, replace the stand. 11. Plug in the computer and turn on power to the computer. 12. Reset the date and time, your passwords, and any special system setups using Computer Setup. 13. Lock any security devices that were disengaged when the access panel was removed. 53
Type 3
a.
Pull back on the clip (1) that is holding the battery in place, and remove the battery (2).
b.
Insert the new battery and position the clip back into place.
Figure B-3
Removing a Coin Cell Battery (Type 3)
NOTE:
After the battery has been replaced, use the following steps to complete this procedure.
9.
Replace the access panel.
10.
If the computer was on a stand, replace the stand.
11.
Plug in the computer and turn on power to the computer.
12.
Reset the date and time, your passwords, and any special system setups using Computer Setup.
13.
Lock any security devices that were disengaged when the access panel was removed.
53