HP StorageWorks 4/16 HP StorageWorks Fabric OS 5.3.1a release notes (AA-RWEYJ- - Page 26

Closed defect summary Solution When the SFP/XFP power and voltage readings are above or below the range, an excessive number of alert messages were reported. Fixed in Fabric OS 5.3.0b. Third-party application will not work with the 400 MP Router Fast Write application (sends FCP_RSP without sequence initiative). Fixed in Fabric OS 5.3.0b. On the B-Series MP Router Blade or 400 MP Router, the proxy PID is improperly converted to 000000 for an ACC to a REC extended link request when an EX_Port is configured for interop mode. As a result, Tape backup may not work with devices in McDATA edge fabrics across the Router due to an improper response to a REC extended link request to a tape device. Fixed in Fabric OS 5.3.0b. Fabric OS 5.3.0c fixes Table 6 lists defects closed in the Fabric OS 5.3.0c firmware release. Table 6 Fabric OS 5.3.0c closed defects Closed defect summary Solution I/O Ops failure due to incorrect CUP Port PDCM bit for port 256 after firmwareupgrade from FOS v5.1.x to FOSv5.2.x/5.3.x in FICON Fixed in Fabric OS 5.3.0c. environment. With McDATA edge switches in the fabric, 400 MP Router or FR4-18i router port receives periodic RRQ & ABTS frames due to the McDATA switch sending unsupported CT command. Routers don't respond, which causes McDATA switch to retry indefinitely. Fixed in Fabric OS 5.3.0c to reject the unsupported CT command. After switchdisable & switchenable, all 400 MP Routers or FR4-18i routers, proxydevices and nameserver entries no longer match what was previously recorded. "fcrrproxydevshow -a" shows 0 devices and translate domains are missing from the edge fabric. This is due to a timing issue while in open fabric interop mode with i10k switch when 2nd IFL is connected to the same switch in the fabric as the 1st IFL, and 1st IFL is fully up. Fixed in Fabric OS 5.3.0c. Hosts lose paths to targets due to FCR daemon failing to send GA_NXT response from 400 MP Router to host connecting to McDATA switch in open fabric mode. Caused by incorrect domain offset in its address translation. Fixed in Fabric OS 5.3.0c. When FRU in a 4/256 Director is inserted/removed a fruHistoryTrap should be generated, but is not. Fixed in Fabric OS 5.3.0c. Note that fruStatusChangeTrap will not be generated with FRU insert/remove. After upgrading switches to FOS 5.3.0, the Web Tools GUI bar showing the "Initializing Switch Details" will get stuck at 93% if the client's regional and language settings are set to some non-US languages such as Dutch, Russian, and Greek. English, French, German, Italian, Spanish, Portuguese, Simplified Chinese, Traditional Chinese, Japanese and Korean work fine. Fixed in Fabric OS 5.3.0c. A PLOGI received by 400 MP Router or FR4-18i prior to address translation table being programmed may not get the correct domain name offset while operating in the open fabric mode, leading to inability to boot over FCR connection for host that doesn't retry PLOGI. Fixed in Fabric OS 5.3.0c. Web Tools shows Ethernet speed at 0, even though it's operating at correct speed, due to underlying MAPS returning speed type rather than proper speed. Fixed in Fabric OS 5.3.0c. 26