HP StorageWorks 4/32 Brocade Converged Enhanced Ethernet Command Reference v6. - Page 220
dot1x quiet-period, Synopsis, dot1x quiet-period interval, Operands, interval, Defaults, Command
View all HP StorageWorks 4/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 220 highlights
12 dot1x quiet-period dot1x quiet-period Sets the number of seconds that a switch remains quiet between a failed authentication and an attempt to retry authentication. Synopsis dot1x quiet-period interval seconds no dot1x quiet-period Operands interval seconds Specifies the time in seconds between attempts at authentication. The range of valid values is 1-65535. Defaults The default time is 60 seconds. Command Interface configuration mode Modes Description Use this command to set the time in seconds after which a switch attempts to perform authentication after a failed authentication. Use the no dot1x quiet-period command to return to the default setting. When a switch cannot authenticate a client, the switch remains idle for a quiet-period interval of time, then attempts the operation again. Usage Changing the quiet-period interval time to a number lower than the default can result in a faster Guidelines response time. Examples To change the interval time to 200 seconds: switch(config)#interface tengigabiethernet 0/1 switch(conf-if-te-0/1)#dot1x quiet-period 200 See Also none 202 Converged Enhanced Ethernet Command Reference 53-1001347-01