HP StorageWorks 4/32 Brocade Converged Enhanced Ethernet Command Reference v6. - Page 68
The default native VLAN for a converged interface is 1., The range of valid values is 2-3583.
View all HP StorageWorks 4/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
3 switchport converged switchport converged Adds or removes native and tagged VLANs on a Layer 2 interface. Synopsis switchport converged { vlan vlan_id | allowed vlan {add vlan_id | all | except vlan_id | none | remove vlan_id} } no switchport converged Operands vlan vlan_id Sets the default native VLAN for the Layer 2 interface. allowed vlan Sets the VLANs that will transmit and receive through the Layer 2 interface. add vlan_id Adds a VLAN to transmit and receive through the Layer2 interface. The range of valid values is 2-3583. all Allows all VLANs to transmit and receive through the Layer 2 interface. except vlan_id Allows all VLANs except the VLAN ID to transmit and receive through the Layer 2 interface. The range of valid values is 2-3583. none Allows no VLANs to transmit and receive through the Layer 2 interface. remove vlan_id Removes a VLAN that transmits and receives through the Layer 2 interface. The range of valid values is 2-3583. Defaults The default native VLAN for a converged interface is 1. Command Interface configuration mode Modes Description Use this command to add or remove tagged VLANs on a Layer 2 interface. Usage There are no usage guidelines for this command. Guidelines Examples To set the native VLAN of 200 on an interface: switch(conf-if-te-0/19)#switchport converged vlan 200 To set the tagged VLAN on an interface to 100: switch(conf-if-te-0/19)#switchport converged allowed vlan add 100 To remove the tagged VLAN 100 from the interface: switch(conf-if-te-0/19)#switchport converged allowed vlan remove 100 See Also show vlan brief, show interface switchport, switchport mode, switchport trunk 50 Converged Enhanced Ethernet Command Reference 53-1001347-01