HP StorageWorks 4/32 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 272
FW-1219, FW-1240, FW-1241
View all HP StorageWorks 4/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 272 highlights
30 FW-1219 Recommended Action You should configure a five- or six-figure high boundary for this area. Only five-figure (or higher) values for CRC errors indicate problems. When an "above" message is received, check for a faulty cable or deteriorated small form-factor pluggable (SFP). Replace the cable or SFP if necessary. Try cleaning the connectors. Check for damage from heat or deterioration from age. Severity WARNING FW-1219 Message , [FW-1219], ,, INFO, , , is between high and low boundaries(High=, Low=). Current value is . Probable Cause Indicates that the number of cyclic redundancy check (CRC) errors has changed from a value outside of the acceptable range to a value within the acceptable range. This indicates that errors have been detected in the FC frame. Invalid CRC messages occur when the number of CRC errors in Fibre Channel frames for specific source ID (S_ID) and destination ID (D_ID) pairs change. These messages might also be caused by dirty equipment, temperature fluctuations, and aging equipment. You should set your high boundaries to five- or six-digit figures, as only large numbers of messages indicate a problem in this area. Recommended No action is required. Respond to this message as is appropriate to the particular policy of the Action end-user installation. Severity INFO FW-1240 Message , [FW-1240], ,, INFO, , , value has changed(High=, Low=). Current value is . Probable Cause Indicates that the number of end-to-end (EE) cyclic redundancy check (CRC) errors has changed. Invalid CRC messages occur when the number of CRC errors in Fibre Channel frames for specific source ID (S_ID) and destination ID (D_ID) pairs change. These messages might also be caused by dirty equipment, temperature fluctuations, and aging equipment. Recommended No action is required. Respond to this message as is appropriate to the particular policy of the Action end-user installation. Severity INFO FW-1241 Message , [FW-1241], ,, INFO, , , is below low boundary(High=, Low=). Current value is . 220 Fabric OS Message Reference 53-1000600-02