HP StorageWorks 4/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 455

66 SULB-1010 SULB-1010 Message , [SULB-1010], , AUDIT, INFO, , Firmwarecommit failed (status=0x). Probable Cause Indicates that the firmwareCommit failed. The error code provides debugging information. See Table 7for more information. Recommended If the failure is caused by an inconsistent filesystem, contact your switch service provider. Action Severity INFO SULB-1011 Message , [SULB-1011], ,, INFO, , Firmwaredownload command failed. state: 0x, status: 0x. Probable Cause Indicates that the firmwareDownload command failed. The additional state code indicates where in the process it failed. Status code provides debugging information (see the tables in message 1109). Recommended Action Run the firmwareDownloadStatus command for more information. Refer to the Fabric OS Administrator's Guide for troubleshooting information. Severity INFO SULB-1017 Message , [SULB-1017], , AUDIT, ERROR, , Firmwaredownload failed in slot . Probable Cause Indicates that firmwareDownload failed in the specified blade. The error may be caused by an inconsistent AP blade firmware stored on the active CP. It may also caused by an internal Ethernet issue or by a persistent storage hardware failure. Recommended Action Run the slotShow command. If the blade is in a FAULTY state, run the slotPowerOff and slotPowerOn commands to trigger another firmwareDownload. If the blade is stuck in LOADING state, remove and re-insert the blade to trigger another firmwareDownload. If the problem persists, contact your switch service provider. Severity ERROR SULB-1018 Message , [SULB-1018], , AUDIT, ERROR, , Firmwaredownload timed out in slot . Fabric OS Message Reference 407 53-1000437-01