HP StorageWorks 8/80 HP StorageWorks 8GB SAN Switch hardware reference guide ( - Page 40
To attach the inner rails to the FCoE Converged Network Switch, Encryption SAN Switch, or,
View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
• For an HP System/e Rack, install two #10-32 x 1/2-inch Phillips panhead screws with captive star lock washers and two #10 alignment washers in the upper and lower holes on the right rail. Then, install two #10-32 x 1/2-inch Phillips panhead screws with captive star lock washers and two #10 alignment washers in the upper and lower holes on the left rail. (See Figure 18.) Figure 18 Assembling the outer rails (HP System/e rack) . 5. See Table 6 to determine the screw type and the number of screws required for your device. CAUTION: Use only the screws that have been provided. Using longer screws can cause damage to internal components. Table 6 Screws required to assemble the inner rails Device 8/8 SAN Switch 8/24 SAN Switch 8/40 SAN Switch 8/80 SAN Switch #8-32 x 5/16-inch screws Ten (five per rail) Encryption SAN Switch FCoE Converged Network Switch 1606 Extension SAN Switch Six (three per rail) #8-32 x 3/16-inch screws N/A N/A 6. Identify the screw holes to attach the inner rails to your device: • To attach the inner rails to the 8/8 or 8/24 SAN Switches, use the five screw holes marked 8. The plenum requires one screw hole marked 8 and one screw hole marked 16, as shown in Figure 21 on page 42. • To attach the inner rails to the 8/40 or 8/80 SAN Switches, use the screw holes marked 16, as shown in Figure 20 on page 41. • To attach the inner rails to the FCoE Converged Network Switch, Encryption SAN Switch, or 1606 Extension SAN Switch, use two screw holes marked R and one screw hole marked 16. 40 Installing and configuring an 8-Gb SAN Switch