HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2.0b release notes (5697-0352 - Page 14

4/256 SAN Director blade support Fabric OS 6.2.0b is fully qualified and supports the Director blades listed in Table 2. Table 2 4/256 SAN Director blade support matrix Director blade FC4-16 FC4-32 FC4-48 FC8-16 FC8-32 FC8-48 FC10-6 Number of blades Supported with any mix, and up to eight blades of each type. No intermix restrictions. The 4/256 SAN Director must run Fabric OS 6.0.0b or later to support the FC816 port blade, and Fabric OS 6.1.0a or later to support the FC8-32 and FC8-48 port blades. FC4-16IP (iSCSI blade) Up to four blades of this type FR4-18i (FCIP/FC Router blade) Up to two blades of this type. Up to eight FR4-18i blades can be installed if they are used only for FC Fast Write or FCIP without routing. DC SAN Backbone and DC04 SAN Director blade support Fabric OS 6.2.0b is fully qualified and supports the DC Director blades listed in Table 3. Table 3 DC Director blade support matrix Director blade FC8-16 FC8-32 FC8-48 FC10-6 Number of blades Supported with Fabric OS 6.0.0b and later with any mix and up to eight blades of each type on DC SAN Director Backbone. No intermix restrictions. The DC04 SAN Director requires Fabric OS 6.2.0a and later, and supports up to 4 blades. FC4-16IP (iSCSI blade) Not supported with the DC SAN Director Backbone, or DC04 SAN Director FR4-18i (FCIP/FC Router blade) Supported with Fabric OS 6.0.0b and later with a maximum of four blades of this type on DC SAN Director Backbone. Up to eight FR4-18i blades can be installed if they are used only for FC Fast Write or FCIP without routing in the DC SAN Director Backbone. The DC04 SAN Director requires Fabric OS 6.2.0a and later, and supports up to 4 blades. FS8-18 (HP DC Switch Encryption FC blade) Supported with Fabric OS 6.2.0b and later with a maximum of four blades of this type on DC SAN Director Backbone and DC04 SAN Director. 14