HP Vectra XE310 hp vectra xe310, upgrade guide - Page 24

Installing a Drive in the Lower Expansion Bay, Upgrading and Replacing PC Hardware, For your safety

Get HP Vectra XE310 PDF manuals and user guides View all HP Vectra XE310 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Upgrading and Replacing PC Hardware Installing a Drive in the Lower Expansion Bay WARNING For your safety, disconnect the power cord and all external cables. 1 Switch off the PC, disconnect the power cord and remove the PC's side panel and air flow guide (refer to "Removing and Replacing the Side Panel & Air Flow Guide" on page 12). 2 Remove the plastic masking plate from the front panel by prising the retaining tab open with a screwdriver. masking plate retaining tab 3 Check that the jumpers on the rear of the new drive are set to CS (cable select) mode. 4 Slide the drive in from the front of the PC, aligning it with the drive in place in the shelf above. 5 Tighten the two screws that fasten the drive to the bay. 6 Connect the data and power cables, and for a DVD or CD-ROM drive, the audio cable. • If this is the second device installed in the expansion bays, fit the data connector marked SLAVE. • If this is the only device, fit the end CD connector marked MASTER. 24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
Upgrading and Replacing PC Hardware
Installing a Drive in the Lower Expansion Bay
WARNING
For your safety, disconnect the power cord and all external cables.
1
Switch off the PC, disconnect the power cord and remove the PC’s side panel and air flow guide (refer
to “Removing and Replacing the Side Panel & Air Flow Guide” on page 12).
2
Remove the plastic masking plate from the front panel by prising the retaining tab open with a
screwdriver.
masking plate
retaining tab
3
Check that the jumpers on the rear of the new drive are set to CS (cable select) mode.±
4
Slide the drive in from the front of the PC, aligning it with the drive in place in the shelf above.±
5
Tighten the two screws that fasten the drive to the bay.±
6
Connect the data and power cables, and for a DVD or CD-ROM drive, the audio cable.±
•
If this is the second device installed in the expansion bays, fit the data connector marked
SLAVE
.
•
If this is the only device, fit the end CD connector marked
MASTER
.
24±