HP t1000 T1500/T1510 Windows-based Terminal Network Installation Guide - Page 63
“G-Key Reset” Procedure, GEND OF QUICK START INSTRUCTIONS
View all HP t1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
T1500/T1510 Windows-Based Terminal Quick-Start Guide 49 7. To further configure the network setup, use the Select | System | Setup window's Connectivity dialog boxes. Most of the information can be supplied by your network administrator: • For ethernet networking, make entries in the Internet dialog boxes. • For serial networking (network connection through a server), make entries in the Serial Ports and Serial Internet dialog boxes. Press the Connect button in the Serial Internet dialog box to make the connection. 8. To ensure access to the on-line help after access to the network is established, perform the following: a. Press the Select button at the lower-left corner of the desktop and select System. In the Select | System pop up menu, select Browser Location. In the Browser Launch dialog box, select Local, then select Save. (The local browser is the default and normally is already selected, but you should perform this step to be sure.) b. Press the Select button at the lower-left corner of the desktop again and select System. In the Select | System pop up menu, select Setup. This opens the Setup window. The Setup window has a menu bar from which dialog boxes may be opened. c. In the Setup window's Administration|Network Services dialog box, in the Help text box enter the IP address and path where the detailed on line help files reside. (The help files should be installed on a server by a network administrator. Refer to the server setup instructions starting in Chapter 1 of this document for instructions). END OF QUICK START INSTRUCTIONS - Make any other desired selections in the remaining Setup window's dialog boxes. For more information, refer to the complete help instructions, which you should now be able to access via the network. It is suggested that before turning the terminal over to a user all Connectivity and Administration settings be made and the Administrator and VNC passwords be changed from their defaults to assure security. "G-Key Reset" Procedure You may reset the terminal software settings by using the G-Key Reset procedure: • Turn on power and upon hearing the first beep immediately press the G key. The beep occurs coincident with expansion of the splash screen to full window size. The Login dialog box displays only if security is enabled, in which case enter a valid administrator or user login name and password. OR