Hitachi 57F500 Owners Guide - Page 37

VIDEO Manual Convergence Adjustment Mode NOTES: 1. Please turn ON your television for at least 20 minutes before using this feature. 2. Auto Adjustment Mode is recommended. If convergence is still not acceptable, use the Manual Adjustment Mode. DO NOT press MAGIC FOCUS or use Auto Adjustment Mode after using Manual Adjustment Mode. Using the Remote Control, select VIDEO-MAGIC FOCUS-MANUAL ADJUSTMENT MODE-START to access convergence crosshatch pattern. The adjustment point is indicated by the Adjustment Point Cursor. To Move Adjustment Point To move the Adjustment Point Cursor, use the CURSOR buttons. The Adjustment Point Cursor must be WHITE. Another way to move the Adjustment Point Cursor is to press the followiing buttons: [2] up, [4] left, [5] down, [6] right. If you use the number buttons while the adjustment point is WHITE, it will change to RED. To Change the Color of Adjustment Point Press the SELECT button repeatedly (WHITE-RED-BLUE-WHITE...). Green color is fixed and cannot be adjusted. To Adjust the Convergence Move the Adjustment Cursor to the point to be adjusted. Use the CURSOR to match the RED and BLUE colors to GREEN (reference color). Properly aligned, all three colors should appear white. MENU Video Audio Ch. Manager Locks Setup Move SEL Sel Video Magic Focus Aligns the Red, Green, and Blue colors to correct for Magnetic Influences. Adjustment Mode Auto Manual If you want to adjust now Start Move SEL Return CURSOR CURSOR CURSOR Video Picture Mode Contrast Brightness Color Tint Sharpness Vertical Position Magic Focus Color System Advanced Settings Move SEL Select Sports 100% 50% 50% 50% Adjustment Point Cursor CURSOR SELECT If convergence is acceptable after Manual Convergence adjustment, press EXIT button to access menu mode. DONE : [1] EXIT CANCEL : [2] INI. RESET : [3] BACK : [4] ON-SCREEN DISPLAY Press the [1] button on the remote control to SAVE adjusted data and return to main picture. Press the [2] button on the remote control to CANCEL adjusted data and return to main picture. Press the [3] button on the remote control to recall the factory pre-set convergence data. Press the [4] button on the remote control to return to the manual convergence adjustment mode (crosshatch pattern). Press the [9] button on the remote control to read the SAVED adjusted data. If there is no saved data, pressing the [9] button will recall the factory pre-set data. 37