Hitachi CM4SB2 Instruction Manual - Page 14
Cutting Procedures
UPC - 717709011120
View all Hitachi CM4SB2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
English CUTTING PROCEDURES 1. Set the machine body (base) on the material to be cut; use the side on the base to align the diamond wheel with the cutting line. (Fig. 5) 2. Turn the switch ON with the diamond wheel initially kept off the material to be cut. The power switch is turned ON when the trigger is pulled by one's finger, and is turned OFF when the trigger is released. If the stopper is depressed after the trigger is pulled, the power switch becomes locked, even though the trigger is released, proving particularly convenient for continuous operation. When the power switch is to be turned OFF, the stopper can be released by pulling the trigger, and the power switch is turned OFF upon releasing the trigger. Base Cutting line Fig. 5 Guide line on the base Guide line on the base CAUTION: ● Do NOT use the diamond wheel for cutting along curves or at angles; otherwise, it may be damaged, resulting in extremely shortened service life. ● Before starting to cut, confirm that the diamond wheel has attained full-speed revolution. ● Should the diamond wheel stop or make an abnormal noise while operating, promptly turn OFF the switch. ● Always take care in preventing the power cord from coming near to the revolving diamond wheel. ● When finished with a job, pull out the plug from the power receptacle. 14