Hitachi CM621F User Manual - Page 4

Cautions - specifications

Get Hitachi CM621F - 17inch CRT Display PDF manuals and user guides
UPC - 050585655621
View all Hitachi CM621F manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

CAUTIONS NEVER REMOVE THE REAR COVER ! The rear cover MUST be removed only by authorized service personnel. This colour monitor contains high voltage components. THE RECEPTACLE SHOULD BE CLOSE TO THE MONITOR AND EASILY ACCESSIBLE ! INSTALL THE UNIT IN A SUITABLE ENVIRONMENT ! DO NOT expose this monitor to rain or moisture to prevent electric shock or fire hazard. This unit is designed to be used in an office or business environment. DO NOT subject the unit to vibrations, dust, or corrosive gases. KEEP IN A WELL VENTILATED PLACE ! DO NOT cover this monitor or place anything against any sides (not only the top, right and left side but also the rear and bottom side ) of unit. Ventilation holes are provided at all sides of the rear cover to prevent the temperature from rising. KEEP AWAY FROM HEAT SOURCES ! AVOID placing the unit in direct sunshine or near a heating appliance. BE CAREFUL OF MAGNETIC FIELDS ! DO NOT place a magnet, loudspeaker system, floppy disk drive, printer, or anything which will generate magnetism near the unit. A magnetic field may cause blurred colours or distortion of the displayed pattern. BE CAREFUL OF GENERATED MAGNETISM ! After the power has been turned on or "DEGAUSS" button has been pressed, the CRT is demagnetized for approximately 10 seconds. This generates a strong magnetic field around the front cover which may affect the data stored on magnetic tape or disks near the front cover. Place such magnetic recording equipment and tapes/disks away from this unit. AMBIENT ILLUMINATION Avoid direct rays of the sun or room lighting onto the CRT screen in order to prevent eye fatigue. THE ENCLOSED POWER CORD MUST BE USED ! In Europe, a proper European standard approved power cord is to be used with this monitor. For a rated current up to 6 A, a type not lighter than H05VV-F 3G 0.75 mm2 or H05VVH2-F 3G 0.75 mm2 must be used. In USA/Canada, use a UL LISTED/CSA LABELLED or CERTIFIED power cord set meeting the following specifications Rating: min. 125V, 7A Length: max. 3.0m Type: SVT or SJT Plug type: NEMA 5-15P figure, Parallel blade, Grounding type Failure to do so may cause fire or electric shock hazard. USE ONLY THE CORRECT VOLTAGE POWER OUTLET WITH SAFETY GROUND CONNECTION ! 100 - 120 V for USA, Canada, etc. 200 - 240 V for Europe, etc. (This monitor will automatically adjust to the input voltage 100 - 120 / 200 - 240V.) 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
3
CAUTIONS
NEVER REMOVE THE REAR COVER !
The rear cover MUST be removed only by authorized service personnel.
This colour monitor
contains high voltage components.
THE RECEPTACLE SHOULD BE CLOSE TO THE MONITOR AND EASILY ACCESSIBLE
!
INSTALL THE UNIT IN A SUITABLE ENVIRONMENT !
DO NOT expose this monitor to rain or moisture to prevent electric shock or fire hazard.
This unit
is designed to be used in an office or business environment.
DO NOT subject the unit to vibrations, dust, or corrosive gases.
KEEP IN A WELL VENTILATED PLACE !
DO NOT cover this monitor or place anything against any sides
(not only the top,
right and left
side but also the rear and bottom side ) of unit.
Ventilation holes are provided at all sides of the
rear cover to prevent the temperature from rising.
KEEP AWAY FROM HEAT SOURCES !
AVOID placing the unit in direct sunshine or near a heating appliance.
BE CAREFUL OF MAGNETIC FIELDS !
DO NOT place a magnet, loudspeaker system, floppy disk drive, printer, or anything which will
generate magnetism near the unit.
A magnetic field may cause blurred colours or distortion of the
displayed pattern.
BE CAREFUL OF GENERATED MAGNETISM !
After the power has been turned on or “DEGAUSS” button has been pressed, the CRT is
demagnetized for approximately 10 seconds. This generates a strong magnetic field around the
front cover which may affect the data stored on magnetic tape or disks near the front cover.
Place
such magnetic recording equipment and tapes/disks away from this unit.
AMBIENT ILLUMINATION
Avoid direct rays of the sun or room lighting onto the CRT screen in order to prevent eye fatigue.
THE ENCLOSED POWER CORD MUST BE USED !
In Europe, a proper European standard approved power cord is to be used with this monitor.
For
a rated current up to 6 A, a type not lighter than H05VV-F 3G 0.75 mm
2
or H05VVH2-F 3G 0.75
mm
2
must be used.
In USA/Canada, use a UL LISTED/CSA LABELLED or CERTIFIED power cord set meeting the
following specifications
Rating: min. 125V, 7A
Length: max. 3.0m
Type: SVT or SJT
Plug type: NEMA 5-15P figure, Parallel blade, Grounding type
Failure to do so may cause fire or electric shock hazard.
USE ONLY THE CORRECT VOLTAGE POWER OUTLET WITH SAFETY GROUND
CONNECTION !
100 - 120 V
for
USA, Canada, etc.
200 - 240 V
for
Europe, etc.
(This monitor will automatically adjust to the input voltage 100 - 120 / 200 - 240V.)