Hitachi DH24PC3 Instruction Manual - Page 11
Confirming condition of the environment, Mounting the drill bit, Installation of dust cup or dust, - sds hammer drill
UPC - 717709009981
View all Hitachi DH24PC3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
English 5. Confirming condition of the environment: Confirm that the work site is placed under appropriate conditions conforming to prescribed precautions. 6. Mounting the drill bit (Fig. 2) CAUTION: Front cap Part of SDS-plus shank Grip To prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle. NOTE: Drill bit When using tools such as bull points, drill bits, etc., make sure to use the Fig. 2 genuine parts designated by our company. (1) Clean the shank portion of the drill bit. (2) Insert the drill bit in a twisting manner into the tool holder until it latches itself. (Fig. 2) Grip (3) Check the latching by pulling on the drill bit. (4) To remove the drill bit, fully pull the grip Fig. 3 in the direction of the arrow and pull out the drill bit. (Fig. 3) 7. Installation of dust cup or dust collector (B) (Optional accessories) (Fig. 4, Fig. 5) When using a rotary hammer for upward drilling operations attach a dust cup or dust collector (B) to collect dust or particles for easy operation. ⅜ Installing the dust cup Use the dust cup by attaching to the drill bit a shown in Fig. 4. When using a bit which has big diameter, enlarge the center hole of the dust cup with this rotary hammer. ⅜ Installing dust collector (B) When using dust collector (B), insert dust collector (B) from the tip of the bit by aligning it to the groove on the grip (Fig. 5) Dust cup Fig. 4 Dust collector (B) Fig. 5 11