Hitachi NV75AG Instruction Manual - Page 13
English - coil nails
UPC - 717709007222
View all Hitachi NV75AG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
(2) Adjust the position of the plate according to the nail length. The nail will not feed smoothly if the plate is not correctly adjusted. First nail Guide slot English Magazine Magazine Nail holder cover NOTE: Before loading nails in the magazine, adjust the plate. If the magazine cover is forcibly closed without adjusting the plate correctly, the nail holder may be damaged. 1 Turn the nail holder about 90 degrees counterclockwise. 2 Slide in vertical direction possible. Lift or lower the nail holder to accept different length nails. 3 Adjust the plate to the nail length reference points on the magazine cover and turn the nail holder 90 degrees clockwise until you hear "click". Magazine 13/4 2 2 21/4 23/8 21/2 3 3 1 Nail holder (3) Place the nail coil into the magazine. Uncoil enough nails to reach the driving hole. Magazine Magazine cover Nail holder First nail Nails Pawl 1 Pawl 2 Driving hole Plastic sheet collated nails Insert the first nail into the driving hole and the second nail between the two pawls of the feeder. Fit the nail head and upper side of the plastic sheet in the guide slot. Fit the lower side of the plastic sheet in the guide slot for plastic sheets. Guide slot First nail Pawl 1 Driving hole Guide slot for plastic sheet Pawl 2 (4) Close the magazine cover first and swing the nail guide closed. (5) Lock the knob correctly. Knob Nail guide Magazine cover NOTE: Be careful not to deform the collated wires and not to disengage the nails with the guide surface. Otherwise, the nail guide will not close correctly. Wire collated nails Insert the first nail into the driving hole and the second nail between the two pawls of the feeder. Fit the nail head in the guide slot. - 13 -