Homelite HGCA4500 User Manual - Page 15

assembly WARNING: Do not attempt to operate the generator until assembly is complete. Failure to comply could result in possible serious personal injury. LOOSE PARTS LIST See Figure 2. The following items are included with the generator: Key No. 1 2 3 4 5 6 7 8 9 10 11 Description Qty. Wheel 2 Spacers 4 Bolts 2 Axles 2 Lock Nuts 2 Bottle of Engine Lubricant 1 Pins 2 Lock nuts 6 Feet 2 Handles 2 Spark plug wrench (not shown 1 Operator's Manual (not shown 1 UNPACKING This product requires assembly.  Carefully cut the box down the sides then remove the machine and any accessories from the box. Make sure that all items listed in the packing list are included. NOTE: This machine is heavy and requires a minimum of two people to lift. To avoid back injury, lift with your legs and not your back. WARNING: This new product has been shipped in a partially assembled condition as described below. Carefully check the packing list below to ensure all items are included in the package; the packing list describes all loose items that are not assembled to the product as shipped. Do not operate the product if any packing list items are already assembled to your product when you unpack it. Call the customer service number below for assistance. Operation of a product that may have been improperly preassembled could result in serious personal injury.  Inspect the unit carefully to make sure no damage occurred during shipping.  Do not discard the packing material until you have ­carefully inspected and satisfactorily operated the p­ roduct.  If any parts are damaged or missing, please call 1-800-242-4672 for assistance. WARNING: If any parts are damaged or missing do not operate this product until the parts are replaced. Failure to heed this warning could result in serious personal injury. WARNING: Do not attempt to modify this product or create accessories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. WARNING: Do not attempt to operate the generator until assembly is complete. Failure to comply could result in possible serious personal injury. NOTE: Do not put fuel or lubricant in the generator before installing the feet and wheels. installing feet See Figure 3.  Raise the end of the generator where the recoil starter is located high enough to gain access to the frame bottom; securely position props underneath to support.  Locate the following items: 2 foot/leg assemblies 4 lock nuts  Insert bolts for a foot/leg assembly through the holes on one side of the frame as shown.  Install nuts and tighten securely.  Repeat with remaining foot. installing the wheels See Figure 4. Wheels are provided to assist in moving the generator to the desired location and should be installed on the side opposite the recoil starter.  Locate the following items: 2 axles 2 wheels 2 lock nuts 2 pins  Raise the end of the generator opposite the recoil starter high enough to gain access to the frame bottom; securely position props underneath to support.  Slide an axle through the hole in the frame as shown. Page 11 - English