Honeywell 5804 Installation Guide - Page 1
Honeywell 5804 - Ademco Wireless Key Manual
UPC - 781410005129
View all Honeywell 5804 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
N7674-6V2 10/04 Rev. A ADEMCO 5804E WIRELESS KEY TRANSMITTER INSTALLATION AND SETUP GUIDE GENERAL INFORMATION The ADEMCO 5804E is a compact, 4-button portable wireless transmitter intended for use only with wireless alarm systems that support 5800 Series receivers. Each button on the transmitter may be programmed for any zone response, but is typically used for arming and disarming. This device supports the High-Security mode, which sends rolling-code encrypted messaging to the RF receiver. Important Note: This device must be used with a 5881EN or a 6128RF (UL version) receiver. The 5804E is powered by two replaceable lithium batteries designed to provide up to 4 years of life. For battery installation, see Replacing the Batteries. PROGRAMMING Each 5804E is assigned a unique serial number during manufacture. Each button on the unit also has a distinct "loop" number (refer to Figure 1) that you must program into the control panel during installation. Assign each button to an individual zone and designate the Input Type as "BR" (Button Type RF). When you are prompted for the serial number, either press and release twice the button you are programming, or enter it manually through the keypad. For complete details on how to program the 5804E transmitter's serial number at the control panel, see the control unit's installation instructions. Note: Buttons on this transmitter must be pressed for at least 1/2 second to activate the transmitter. This feature minimizes the possibility of accidental transmissions. ACTIVATING HIGH-SECURITY MODE If Programming 5804E in the Control 1. Program the button in the control. 2. After programming is complete, exit programming mode and wait 60 seconds. 3. Put the system in Go/No Go mode. 4. Press all 4 buttons on the 5804E at the same time until the panel beeps. 5. To sync the device in High Security Mode, press any button ONCE, until the panel beeps indicating receipt. NOTE: If no beep is heard, exit Go/No Go mode, and repeat this procedure from Step 3. 6. Exit Go/No Go mode (user code + 1 (OFF)). LOOP 3 OFF ON LOOP 2 LOOP 4 LOOP 1 5804E-001-V0 Figure 1: 5804E showing button designations PROGRAMMING THE 5804E LOCALLY IN AN RF KEYPAD (E.G., 6150RF) Hold all 4 buttons down while enrolling the serial number in the RF keypad. USING TWO RECEIVERS IN HIGHSECURITY MODE Enroll the 5804E into the receivers one at a time, by disconnecting Receiver #2, enrolling as described in "Activating High Security Mode" (above). Then, disconnect Receiver #1, reconnect Receiver #2, and repeat the enrollment procedure. This process ensures proper High Security operation with both receivers. APPLYING COLORED ADHESIVE LABELS AND BUTTONS The 5804E is supplied with colored buttons (red and blue) and colored adhesive identification labels (blue, red, gray, and green). Each label has a specified command function and symbol printed on it, as well as an adhesive back for easy pasting. To paste a label on a button, slowly peel off a label with a selected function and paste it on the button of the transmitter. If you decide later to reenroll a button, the label can be easily removed or a new label pasted over the existing one. Additional colored buttons (red and blue) are also provided which can be used with or without the labels. The buttons can be inserted only in the areas provided for them (see Figure 3).