Honeywell 6149EX Installation Guide - Page 1
Honeywell 6149EX Manual
View all Honeywell 6149EX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
K6205EXV3 5/07 Rev. B ADEMCO 6149EX & 6165EX Remote Keypads INSTALLATION AND SETUP GUIDE GENERAL INFORMATION The ADEMCO 6149EX and ADEMCO 6165EX are addressable remote keypads designed for use with ADEMCO control panels. The keypads have the following features: • Built-in Piezo • Special Function Keys Addresses are set via the keypad keys, which are continuously backlit for convenience. KEYPAD DISPLAYS AND LEDS The keypads have the following display features: Model Fixed 2-line Word Alpha Display Display 2-digit Custom Zone Zone Identifier Descriptors Backlit Display 6149EX 6165EX * * Permanent display backlighting is an option on some control panels (refer to the Control's Installation and Setup Guide for details). The following table shows the LEDs and their functions: LED Function ARMED (Red) Lights when the system is armed in any mode READY (Green) Lights when the system is "ready" to be armed. MOUNTING AND WIRING THE KEYPAD The keypad must be mounted within the protected premises. It can be surface mounted directly to walls. A built-in tamper switch detects separation of the case-back from its mounting surface. To include tamper protection, a tamper screw must be inserted in the case-back, as shown in Figure 2. NOTE: Not all control panels support keypad tamper reporting. Refer to the individual Control Panel's Installation and Setup Guide. Figure 1 - 6149EX/6165EX Keypad (shown with cover removed) SPECIAL FUNCTION KEYS The keypads also feature function keys. These keys may be programmed for panic alarms or other special functions such as macros. See the control's instructions for details. Function keys must be held down for at least two (2) seconds to activate an alarm. Key pairs activate immediately. Special Function Keys A or [1] and [✻] B or [✻] and [#] C or [3] and [#] D Figure 2 - Mounting the keypad 1. Separate the case back from the keypad. 2. If using the tamper switch place the case back on a flat surface and insert a screw through the tamper switch plunger in the case back, as shown in Figure 2. Tighten the tamper screw until the upper portion of the tab (near the tamper screw) contacts the case back. 3. Route wiring from the control panel through the opening in the case back. 4. Mount the case back to a wall. 5. Wire directly from the keypad's terminal block to the terminal block on the control board as follows: Keypad GL − + MY Wiring Table (All Keypads) Control Panel Wire Color Data In Green − Aux Pwr (GND) Black + Aux Pwr Red Data Out Yellow Refer to the control panel's Installation and Setup Guide for more complete details. 6. Reattach the keypad to its case back.