Honeywell 6460S Installation Guide - Page 1
Honeywell 6460S Manual
View all Honeywell 6460S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
800-03612 1/09 Rev. B ADEMCO 6460S/6460W REMOTE KEYPAD INSTALLATION AND SETUP GUIDE GENERAL INFORMATION The ADEMCO 6460S (silver) and 6460W (white) are addressable Remote Keypads designed for use with Honeywell's ADEMCO series control panels. Addresses are set via the keypad keys. The keys on the keypad are continuously backlit for convenience. NOTE: If supported, the ADEMCO 6460S and 6460W keypads are supervised by control panel. Supervision must be enabled for commercial fire installations. KEYPAD DISPLAYS AND LEDS The ADEMCO 6460S and 6460W keypads have the following display features: • 2-line Alpha Display • Custom Zone Descriptors • Built-in Speaker Sounder • Dedicated Function Keys • Backlit Display (permanent display backlighting is an option on some controls; see the control's instructions for details). The following table shows the LEDs and their functions: LED Red Green Function Lights when the system is armed in any mode Lights when the system is "ready" to be armed. SPECIAL FUNCTION KEYS The keypads also feature function keys. These keys may be programmed for panic alarms or other special functions such as macros. See the control's instructions for details. Function keys must be held down for at least 2 seconds to activate an alarm; key pairs are activated immediately. Function Keys A or [1] and [✻] B or [✻] and [#] C or [3] and [#] D WIRING AND INSTALLATION The keypads can be surface mounted directly to a drywall, or to a single- or double-gang electrical box. 1. Push the two case release snaps at the bottom of the keypad with the blade of a medium screwdriver (this will push in the release snap), then pull that side of the case back away. Refer to Figure 1 for location of the case back release snaps. 2. Route wiring from the control panel through the opening in the case back. 3. Mount the case back to a wall or electrical box. 4. Wire directly from the keypad's terminal block to the terminal block on the control panel. (See Wiring Table below). NOTE: No more than one wire per terminal may be connected. If daisy-chained configuration is required, pig-tail wires together so that only one wire is terminated under the screw. Use 16-24 AWG wire only! Wiring Table Keypad LG - + MY Control Panel Data In - Aux Pwr (GND) + Aux. Pwr Data Out Wire Color Green Black Red Yellow See the control panel's Installation and Setup Guide for more complete details. 5. Reattach the keypad to its case back. A B CD ARMED READY 1 OFF 4 GHI MAX 7PQRS INSTAN T * END READY 2 ABC AWAY 5 JKL TEST 8 TUV CODE 0 3 DEF STAY 6 MNO BYPASS 9WXYZ CHIME # NUM NOTE: TO REMOVE CASE BACK PUSH IN THE TWO RELEASE SNAPS LOCATED ALONG THE BOTTOM OF THE KEYPAD AND LIFT UP. RELEASE SNAPS Figure 1. Removing the Case Back 6460S-001-V1 WWW.DIYWALWARMWFO.RUDM.ICOYM ALARMFORUM.COM