Honeywell HZ2016 Owners Manual - Page 3

Save These Instructions - thermostat

Get Honeywell HZ2016 - Heat Express Heater Fan PDF manuals and user guides View all Honeywell HZ2016 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

opening as this may cause an electric shock or fire, or damage the heater. 14. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surface, like a bed, where openings may become blocked. 15. A heater has hot and arcing or sparking parts inside. Do not use it in the areas where gasoline, paint, or flammable liquids are used or stored. 16. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. 17. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be No. 14 AWG minimum size and rated not less than 1875 watts. 18. The output of this heater may vary and its temperature may become intense enough to burn exposed skin. Use of this heater is not recommended for persons with reduced sensitivity to heat or an inability to react to avoid burns. 19. SAVE THESE INSTRUCTIONS OPERATION USING THE THERMOSTAT FEATURE • Place the heater on a firm, level surface free from FIG.1 obstructions, and at least 3 ft. (0.9m) away from any wall or combustible material. • DO NOT use on an unstable surface such as bedding HIGH or deep carpeting. Be sure the heater is not in a position LOW POWER where it may be tripped over by small children or pets. FAN OFF • With the Power knob in the OFF position, plug the heater into a polarized outlet. • Turn the Thermostat control fully clockwise to the HIGH (+) setting. • To turn the heater on, rotate the Power knob turning it clockwise to the desired position (Fig. 1). The power light will illuminate. • When the room reaches a comfortable temperature, slowly turn the Thermostat control counter-clockwise until the heater goes off. This is the point at which the Thermostat setting equals the room temperature. At this setting, the thermostat will automatically turn the heater on and off to maintain this selected temperature. • Turn the Power knob to OFF and unplug the heater when you are finished using it. NOTE: DO NOT OPERATE HEATER WHILE CORD IS BUNDLED OR WRAPPED. OTHER FEATURES • To use the unit as an air circulator without heat, turn the Power knob to FAN and the Thermostat to its highest setting. • This heater has a convenient recessed carrying handle. • This heater has a cord wrap for easy storage. 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
opening as this may cause an electric shock or fire, or damage the heater.
14.
To prevent a possible fire, do not block air intakes or exhaust in any manner.
Do not use on soft surface, like a bed, where openings may become blocked.
15.
A heater has hot and arcing or sparking parts inside. Do not use it in the
areas where gasoline, paint, or flammable liquids are used or stored.
16.
Use this heater only as described in this manual. Any other use not recommend-
ed by the manufacturer may cause fire, electric shock, or injury to persons.
17.
Avoid the use of an extension cord because the extension cord may overheat
and cause a risk of fire. However, if you have to use an extension cord, the
cord shall be No. 14 AWG minimum size and rated not less than 1875 watts.
18.
The output of this heater may vary and its temperature m
a
y become intense
enough to burn exposed skin. Use of this heater is not recommended for per-
sons with reduced sensitivity to heat or an inability to react to avoid burns.
19.
SAVE THESE INSTRUCTIONS
OPERATION USING THE THERMOSTAT FEATURE
• Place the heater on a firm, level surface free from
obstructions, and at least 3 ft. (0.9m) away from any
wall or combustible material.
•
DO NOT
use on an unstable surface such as bedding
or deep carpeting. Be sure the heater is not in a position
where it may be tripped over by small children or pets.
•
With the Power knob in the OFF position, plug the
heater into a polarized outlet.
•
Turn the Thermostat control fully clockwise to the HIGH (+) setting.
•
To turn the heater on, rotate the Power knob turning it clockwise to the desired
position (Fig. 1). The power light will illuminate.
•
When the room reaches a comfortable temperature, slowly turn the Thermostat
control counter-clockwise until the heater goes off. This is the point at which the
Thermostat setting equals the room temperature. At this setting, the thermostat will
automatically turn the heater on and off to maintain this selected temperature.
•
Turn the Power knob to OFF and unplug the heater when you are finished
using it.
NOTE: DO NOT OPERATE HEATER WHILE CORD IS BUNDLED OR WRAPPED.
H
IGH
L
OW
F
AN
O
FF
P
OWER
FIG.1
OTHER FEATURES
•
To use the unit as an air circulator without heat, turn the Power knob to FAN
and the Thermostat to its highest setting.
•
This heater has a convenient recessed carrying handle.
•
This heater has a cord wrap for easy storage.
2