Honeywell HZ2300 Owners Manual - Page 4

IOLLASTCIOILNLAFTEIAOTNUREFEATURE To use this feature, slide the Oscillation switch located at the bottom of the heater to ON. The heater will then oscillate 45° to each side. OFATNHEORPEFREAATTIOUNRES • This heater is equipped with a "tip over switch" safety feature which automatically shuts off heating element if heater is not in an upright position. Heat will resume once heater is properly oriented. • This heater is equipped with an internal High limit Switch which causes the unit to stop operating in the event the internal temperature exceeds normal operating temperatures. FAN OPERATION To use the unit as an air circulator without heat, turn the selector knob to FAN and the thermostat to its highest setting. IF YOUR HEATER FAILS TO OPERATE: • Be sure it is plugged in and that the electrical outlet is working. • Check for any obstruction. If you find an obstruction turn the heater OFF. Unplug the heater and wait at least ten minutes for it to cool. Carefully remove the obstruction. Plug the heater back in and restart it as described under OPERATION. • Check that the thermostat is not set too low. With the selector knob set to a heat setting, turn the thermostat up (clockwise) until the heater restarts. NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE WARRANTY FOR INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF. DOING SO MAY VOID THE WARRANTY AND COULD CAUSE DAMAGE OR PERSONAL INJURY. IF THE PROBLEM STILL PERSISTS, PLEASE CALL: Kaz Home Environment CONSUMER RELATIONS DEPARTMENT TOLL FREE: 1-800-332-1110 E-mail: [email protected] Mail questions or comments to: Kaz Home Environment Consumer Relations Dept. 250 Turnpike Road Southborough, MA 01772 U.S.A. Please be sure to specify model number.