Honeywell NX4S1 User Guide - Page 43
Table 2-4, Configuration > Doors > Reader Tab Descriptions
View all Honeywell NX4S1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Configuring via the Web Server Configuring the System Steps: 1. Use the descriptions in the table below to configure the General reader settings. Table 2-4: Configuration > Doors > Reader Tab Descriptions Setting Description Access Mode Specifies the validation conditions required at the door before access is granted. For each access mode, you must also select a time zone from the drop down list. The time zone is the schedule by which the access mode is effective. Disabled - Ignores all card reads (except from a VIP card), allows neither exit nor entry by Card-and-PIN mode or Card-or-PIN mode. Also, free egress is not allowed. Lockdown - Ignores all card reads (except from a VIP card), denies door entry but allows egress. Card and Pin - Grants access only with both a successful card read and a valid PIN entry at the door's keypad. You can perform the card read and PIN entry in either sequence. Card or Pin - Grants access with either a successful card read or a valid PIN number entry at the door's keypad. Pin Only - Grants access with only a valid PIN number entered at the door's keypad. Card Only - Grants access with only a successful card read. Supervisor - Enables a supervisor to enter without allowing access to others. When the supervisor presents his card during the time zone just once, he gains access but does not enable access for non-supervisory personnel. If the supervisor presents his card twice, he enables access for all non-supervisory personnel as well. After the supervisor presents his card twice to allow general access, he can disable the general access for the time zone by presenting his card again twice consecutively. Escort - Requires a supervisor escort for a non-supervisor cardholder. The supervisor must present his card first, then the non-supervisor must present his card within ten seconds of the supervisor's card read. NetAXS™ Access Control Unit User's Guide, Document 800-04410, Revision A 33