Hoover BH55100PC Product Manual - Page 11

Emptying your FloorMate, ® Cordless dirty water tank and filter

Get Hoover BH55100PC PDF manuals and user guides View all Hoover BH55100PC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Emptying your FloorMate® Cordless dirty water tank and filter ! WARNING ! To reduce the risk of personal injury - Remove battery pack before cleaning or servicing. ! CAUTION ! Water will drip from the brushes and underside of the product after use and may puddle. To avoid damage to wood and laminate flooring and to avoid potential slip hazard,after use (a) do not leave the product on wood and laminate surfaces and remove to a hard surface and (b) place unit on absorbent material(such as a towel) to soak up drips. LEFT LEFT FRONT 1 Press this button and pivot the tank out. 2 Release these tabs and pull the tank lid up to remove. 3 Empty water into sink or toilet. Check foam filter for debris and rinse as needed. NOTE: An automatic suction shut-off is built into the dirty water tank to prevent overflowing. When the shut-off activates, the cleaner will not pick up water or debris and the motor sound will change. The dirty water tank is full and must be emptied. ▲ See us do it: hooverhelp.com/FloorMateCordless22 FRONT 4 5 Replace the tank lid and latch both tabs into Snap the tank back into its the locked position. original position. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
CAUTION
Water will drip from the brushes and underside of the
product after use and may puddle. To avoid damage to wood and laminate
flooring and to avoid potential slip hazard,after use (a) do not leave the product
on wood and laminate surfaces and remove to a hard surface and (b) place unit
on absorbent material(such as a towel) to soak up drips.
Emptying your FloorMate
® Cordless dirty water tank and filter
Press this button and
pivot the tank out.
Empty water into
sink or toilet. Check
foam filter for debris
and rinse as needed.
Replace the tank lid
and latch both tabs into
the locked position.
Snap the tank
back into its
original position.
Release these tabs
and pull the tank lid
up to remove.
1
2
3
4
5
8
NOTE:
An automatic suction shut-off is built into the dirty water tank
to prevent overflowing. When the shut-off activates, the cleaner will
not pick up water or debris and the motor sound will change. The
dirty water tank is full and must be emptied.
WARNING
To reduce the risk of personal injury -
Remove battery pack before cleaning or servicing.
!
!
!
!
FRONT
LEFT
FRONT
LEFT
See us do it:
hooverhelp.com/FloorMateCordless22
▲