Hoover F5891 Manual - Page 4
Assemble handle
View all Hoover F5891 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
The assembled cleaner will look like this drawing. Assemble handle Attach upper handle Remove clean solution tank (upper tank) from deep cleaner. With cord hook (A) to back of deep cleaner, push upper handle down onto lower handle. Push bolts into holes on front of handle. If bolts will not go through hole easiioh$dle is not pushed completely - x Place nuts in recessed areas on back of handle. Hold each nut in place while tightening each bolt securely with a Phillips screw driver. Only two nuts are needed on this model. The extra nut is not required but has been provided for your convenience. When handle sections are completely together, squeeze trigger (B) on upper handle to snap tripqer rod In place. Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle to snap top of tank into place. Press cord into cord clip on back of handle. Pull cord tight. 4 Attach hose clip Push tab on side of clip into hole on side of handle. Pivot clip and push other tab into hole at back of handle to lock into place.