Hoover F5918 Manual - Page 13
How to attach tool, Before using tool, After using tool
View all Hoover F5918 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
3-10 3-11 F 3-12 H G 3. Remove recovery tank front panel (F) by sliding it straight up. 4. Replace panel with converter (G). Slide converter halfway down opening until it is firmly in place. 3-13 I 3-14 J 6. The tank replaces in a hinge-like manner. Position front of lid under tabs (I) on front of tank. Rotate lid down onto tank. Make sure lid is secure on all sides before cleaning. For full suction, it is important that the recovery tank lid is properly secured before cleaning. Reverse procedure to remove hose and solution tube. Raise deep cleaner handle to upright position. 3-15 K How to attach tool All tools connect to the hose in the same manner. 1. Attach tool to connector end of hose by sliding it onto connector until the tab (J) locks it securely. Using your thumb, push forward and up on the latch (K) to remove tool as shown. 3-17 5. Before connecting tube (H) to cleaner, make sure black tabs are extended by pulling tan collar toward tube. Open door on hood labeled "Stair/ upholstery Cleaning Connection". Press round solution tube connector onto round projection inside door. Press connector collar down firmly to ensure that it is fully connected. Before using tool It may be necessary to remove air from the system ("prime the pump") so the clean solution will flow to the tool. Follow these steps: 1. Attach tool to hose and turn the deep cleaner ON. 2. Put the tool on a hard surface or against your hand to block off the suction. 3. Wait a few seconds (can take up to 15 seconds). Then squeeze the trigger and begin cleaning. Follow the instructions on pages 14 and 15 for the appropriate cleaning task. 3-18 L 3-16 M After using tool 1. Follow steps a and b for "After cleaning" on page 11. 2. Rinse tool and hose by filling sink with a small amount of water. Turn deep cleaner ON and pick up the water with the tool. 3. Drain suction hose by turning deep cleaner ON and holding end of hose up for several seconds. Do not press trigger. 4. Disconnect deep cleaner from electrical outlet. 5. Drain solution tube by placing round end in sink and raising nozzle above your head. Press the trigger. 6. Proceed with steps c, d and e for "After cleaning" on page 11. Occasionally, debris may become lodged inside of the hose at the converter end (L). To clean out the hose, lift bottom of converter clip (M) with a screwdriver and remove clip. Remove debris as shown. 13